Page 1 of 1

Pvc thickness

Posted: May 25th, 2024, 1:41 pm
by kinkychippy
Hi you kinky people, I'm wanting to order some plastic pants from PVC-you-like. It's the thickness I want to get right, not sure what the numbers mean after the listing on the order form. I want some pvc that isn't to thick ,love there pvc outfits want to stock up my plastic wardrobe. Your help would be appreciated. Thanks in advance.

Re: Pvc thickness

Posted: May 25th, 2024, 6:48 pm
by Cherie
The thickness is in microns. Sometimes PUL get the decimal point int the wrong place, so you see 150u and 0.150u but they mean the same thing. If you want thin then 150u is pretty good but BKS7 and WHT2 say they areas thin as 120u. If you want to be sure you can order a colour chart XX01 for £8.55 which contains samples but I don’t know if they include every available material. I prefer medium weight material for which 200u is as low as I will go before I consider it too thin, but we are all different, so one persons thin might not be someone else’s.

Hope hat helps
Cherie x

Re: Pvc thickness

Posted: May 26th, 2024, 7:52 am
by kinkychippy
Dear Cherie,
Thanks for the message and information, 200 microns is for me I think will order the plastic pants very soon ,kinky chippy xxx

Re: Pvc thickness

Posted: May 26th, 2024, 8:25 am
by Nylon macs
Me to.
I was looking at theme myself and didn't know the best thickness 👍👍👍

Re: Pvc thickness

Posted: May 26th, 2024, 10:30 am
by Cherie
For me there is a sweet spot in weight which is around 240u. At that thickness it is heavy enough so you are made to know you are wearing it, I find very thin plastic doesn’t give a feel as it is so light. If you go too heavy the stiffness keeps the material away from the skin so again you don’t get the feel. But most of my stuff is 200u because that is the most common weight from PUL (which is where most of my outfits come from). But we are all different and some trial and error may be needed until you find your perfect weight.

Cherie x

Re: Pvc thickness

Posted: June 22nd, 2024, 2:30 pm
by raincoatboy
You can't go wrong with PUL. Their standard thickness is 200 microns. Not too thin and not too thick. There are a few exceptions though. They have a black ovc material that is wet look shiny on both sides. I believe it is BKS13. It is only 150 microns I think. They did a limited test run of the same material but it was called BKS10. I bought several items made out of it. I'm so in love with it. I can't put it down.